Roller doors can be an effective solution to open up ceiling space in industrial and commercial properties. Not only are these durable doors easy to operate, but they can be tailored specifically to meet the needs of each space.
Roller doors do need to be maintained, though. A few simple steps can help extend its lifespan and ensure it functions optimally.
Misaligned Parts
Misaligning parts can cause your commercial rollup door various issues, from scraping to uneven wear on components. Rust is often responsible for this misalignment as it alters how your door travels along its tracks, but this could also occur if they are not level with each other or walls/floor. Learn about fastfixrollerdoors.com.au roller door repair Adelaide.
To solve this issue, loosen the bolts that secure each track to its lower bracket using a wrench, and move each track until they’re all upright with each other across their entire length, with no gap larger than 1/4 inch between them and the stop moulding stop mouldings, tighten the screws back up again using a level as a final check to make sure everything remains level with both itself and the wall.
Another frequent cause of misalignment is broken cables. This strain on your system could put additional components out of sync, including sensors that no longer communicate with their remote or motors that work harder than expected and become burned out from the overworked operation.
If the sensors of your door are no longer communicating with your remote control or its motor is failing, an easy and inexpensive solution may be as simple as replacing the batteries. This quick and affordable fix could bring back the full functionality of your door system.
Worn Out End Bearing Plates
Plates on either end of a torsion shaft help keep springs running smoothly by preventing them from tilting or bending, holding their form while providing stability for smooth-running springs. When worn, these plates may allow the springs to grind against their shaft resulting in noisy, complex door operation that’s noisy and hard to open or close.
Search the edges of plates for black dust or powder caused by metal grinding against metal, which indicates wear on parts that could last longer with regular lubrication; it would be wiser, however, to replace worn parts when they show signs of wear for your protection and to avoid future complications.
Resynchronising the opener can be one of the quickest and least costly solutions to door opener problems. However, it would be best to disconnect the power to avoid accidental movements when working on it. Learn about fastfixrollerdoors.com.au roller door repair Adelaide.
Broken Springs
Springs on garage doors act as counterweights to help lift and lower their heavy door panels, but should they break, the job of manually lifting your garage door may become very challenging and dangerous.
Torsion springs – wrapped around a rod above the door opening – can often be identified when they break by hearing an audible snap when one snaps. In addition, stretched-out coils may indicate insufficient bound energy available for this spring to perform its duties effectively.
If your garage doors use extension springs that run along horizontal tracks on each side of the door, replacing them on your own may be possible. As these springs are under less tension than torsion springs, replacing them might be easier; prioritise safety first!
When replacing an extension spring, follow your supplier’s instructions regarding how many turns should be completed. Overwinding can cause it to break or injure you if done improperly; use a ladder to reduce the risk of falls, and ensure the tube is secure once installed to prevent accidental unwinding and possible injury to yourself or someone else.
Faulty Motor
If your motor begins acting up, you must investigate its source. A root cause failure analysis (RCFA) should be performed to identify and understand any stressors that caused its failure and decide if repair or replacement makes more sense; additionally, it will give insight into preventing similar issues in future.
One tell-tale sign that your motor is on its way out is excessive vibration, which could result from loose bearings, misalignment issues or any number of other problems which can contribute to premature failure.